This can be done by simply entering in a valid system user code or the system Master Code. Meanwhile, an alarm reset is the process of clearing the system following an alarm event. Check out this FAQ for resetting a wireless system, as well as this FAQ for resetting a wired system. This process is different for each type of alarm system.

A factory reset, also called factory defaulting, is a special process used to reset every system setting to its factory default settings. There is also a factory reset and an alarm reset. However, a power reset is not the only type of system reset. Then reconnect the battery and transformer to power it back on. To power down the system, the backup battery must be disconnected, and the transformer must be unplugged. You will be required to provide your credit card details before the technical support can be provided. We appreciate your cooperation.You can reset your alarm system by powering it down and then powering it back on.

A minimum fee of $25.00 inc gst applies for up to 15 minutes and is then charged at $1.00 inc gst per minute thereafter. *Please Note – North East Security offer additional technical support over the phone if required. Enter USER CODE to silence beeping keypad. This will perform a Battery, Communicator and Siren test. Simply press the CHIME and ON, your keypad and this will activate it. If you have a zone allocated to DOOR CHIME (would have been arranged when alarm was installed, however can be added by your technician), you are able to initiate this function to let you know when a door has been opened. See list and instructions above, then enter # to exit this feature To silence the keypad, input USER CODE a second time and then enter * then 2 to display fault. If FAULT displays, refer to chart below then enter # to exit featureīEEPING SOUND – If plug pack in unplugged or the mains POWER is disconnected the keypad will SOUND (Beep) Press * then 2 – One or more zones will light If no other sector to isolate then press # To display sectors that casued last alarm conditionĮnter BYPASS then USER CODE – Bypass light will flashĮnter sector (two digit) e.g 03 to isolate sector 3Įnter BYPASS again, followed by next sector to isolate or Keypad Instructions & Faults DAS/Hills Alarm PanelĮnsure READY light is on (All areas are sealed)

Networx alarm system reset